|
Hub assembly
Wheel bearings are lubricated by the "blue" grease MS1510Blue. This lubricant is compatible with lithium grease and high temperature grease and is designed for heavy-loaded units, and also contains antioxidant additives to provide long-term operation at high pressure and temperature.
Castellated nut with a splinting to adjust hub bearing provides reliability of the hub assembly.
|
|
Spare wheel carrier
Spare wheel carrier |
|
Air suspension control valve
Air suspension control valve:
allows to bleed and pump the air suspension before and after unloading |
|
Release valve
Release valve controls the parking brake |
|
Automatic tailgate lock
Automatic tailgate lock:
opening and closing of the tailgate is automatic when lifting and lowering the body. |
|
Tractor connection
Connection to a tractor is by means of a quick disconnect fitting. |
|
Electrics
Electrics.
Electrical equipment uses a harness of traffic signal with a connection socket.
Two-wire scheme. |
|
Hydraulic cylinder equipment
Hydraulic cylinder is equipped with hydraulic decelerator in case of breakage of connecting hoses. |
|
Tarpaulin fixing belt
Tarpaulin fastening belt with a pull-up and lock ratchet |
|
Wheel chocks
Wheel chocks. Each trailer is equipped with several plastic wheel chocks. The number varies depending on the model of the semitrailer. |
|
Axle lifting / lowering mechanism
Axle lifting mechanism (lowering) is driven by a command from the T-EBS block when unloading (loading) the semitrailer |
|
Landing gear
Landing gear does not require significant maintenance:
- Single control;
- Rack with hinged base plate;
- Two-stage gear. |
|
Chassis
Reinforced spring brackets.
Additional reinforced angle braces
Extra accumulators on the axle beam with additional holding arms. |
|
Increase in the thickness of 2 mm of frame spar fl
Updated design: increase in the thickness of 2 mm of frame spar flanges. |
|
Reinforcement of frame side member at spring hange
Reinforcement of frame side member at spring hangers |
|
Reinforcement plate at the rear reinforcement part
Reinforcement plate at the rear reinforcement part of the body |
|
Rear bumper
Updated design: rear bumper is now higher; its design is slightly changed. |
|
Wash-hand-stand
Wash-hand-stand |
|
Additional accumulator support bracket on the axle
Additional accumulator support bracket on the axle beam |
|
New design of the wings
New design of the wings.
This design is borrowed from American and Australian counterparts, which are known by their simplicity and reliability. Such wings are more resistant to mechanical damage during loading and unloading, as well as work in the quarries. |